Studying the calculation process of gear geometry transmission in C++ and excel programs

Studying the calculation process of gear geometry transmission in C++ and excel programs

Authors

  • Uzoqov Farxod G‘afforovich

DOI:

https://doi.org/10.5281/zenodo.14555621

Keywords:

Gear, parameter, measurement parameter, internal module, module, number of teeth, circle, balance, gear wheel, gear.

Abstract

In the article, the parameters of the existing gears and the process of calculating the
internal gear module gear are studied in C++ and Excel programs. The calculation of preparation
in cylindrical, involute, cycloidal, straight screw, chevron, curved, and other forms is also analyzed.

Author Biography

Uzoqov Farxod G‘afforovich

Namangan Institute of Engineering and technology.
“Information technologies” department associate professor

Published

2024-12-07

Issue

Vol. 2 No. 5 (2024): «Muhandislik va Iqtisodiyot» jurnali

Section

Articles

License

Copyright (c) 2024 MUHANDISLIK VA IQTISODIYOT

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.